Herunterladen Inhalt Inhalt Diese Seite drucken

Monacor Measurement DMT-2050 Bedienungsanleitung Seite 19

Digital-multimeter
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
5.2 Resistance measurement
Never measure a resistor when
voltage is applied and always
measure it separately, otherwise
the measurement will be inaccu-
rate. For this purpose, solder it out
of the circuit, if required.
1) Set the orange sliding switch (5)
to the upper position
Neither the diode symbol
the buzzer symbol
played, otherwise press the but-
ton
Ω /
both symbols disappear.
2) Apply the test prods to the resistor
or to the corresponding meas-
uring points.
5.3 Forward voltage of diodes
Never measure a diode when volt-
age is applied and always meas-
ure it separately, otherwise the
measurement will be inaccurate.
For this purpose, solder the diode
out of the circuit, if required.
1) Set the orange sliding switch (5)
to the upper position
Press the button
many times until the diode symbol
is displayed.
2) Apply the black test prod to the
cathode of the diode and the red
test prod to the anode.
3) The display will show the forward
voltage up to 2 V at a test current
of 1 mA. With 0 V displayed, the
diode has a short circuit. With
(4) so many times until
/
Ω /
must be dis-
Ω /
(4) so
Ω /
/
GB
.
/
nor
.
/
19

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis