Monacor Measurement DMT-2050 Bedienungsanleitung Seite 18

5.1 Voltage measurement
GB
WARNING Take
1) Set the orange sliding switch (5)
2) Apply the test prods to the test
3) In case of DC voltage measure-
18
With this meter, no measure-
ments must be carried out in cir-
cuits with corona discharges
(high voltage). Danger to life!
The maximum voltage to be
measured must not exceed
600 V¿ / ~, otherwise you may
risk your life!
to the position VOLT. After switch-
ing on, the DC voltage measure-
ment is always activated: "DC" is
displayed. When measuring AC
voltages, switch to "AC" with the
button DC /AC (4). To return to the
DC voltage measurement, press
the button DC /AC.
object and read the value on the
display.
ments, a minus sign will precede
the measured value if the nega-
tive pole is at the red test prod and
the positive pole is at the black
test prod.
into
unexpected voltages
at test objects. Ca-
pacitors, for example,
may be dangerously
charged even if the
voltage source has
been switched off.
account