Introduction; Intended Use; Equipment; Package Contents - Parkside PEH 30 C3 Originalbetriebsanleitung

ELECTRIC PLANER PEH 30 C3

Introduction

Congratulations on the purchase of your new appli-
ance. You have chosen a high-quality product. The
operating instructions are part of this product. They
contain important information about safety, usage
and disposal. Before using the product, please
familiarise yourself with all operating and safety
instructions. Use the product only as described and
for the range of applications specified. Please also
pass these operating instructions on to any future
owner.

Intended use

The appliance is designed for planing workpieces
such as beams or planks that are firmly held in
place. The appliance is also suitable for chamfer-
ing edges and for grooving. Any other uses of or
modifications to the appliance are deemed to be
improper usage and may result in serious physical
injury. The manufacturer accepts no responsibility
for damage(s) attributable to misuse. This appli-
ance is not intended for commercial use.

Equipment

Safety lock-out
ON/OFF switch
Chip ejector (optionally right/left)
Belt cover
Screws for belt cover
Rip fence
Fastening screw for rip fence
Lock nut for setting the fold width
Connecting piece
8a
8b Connecting screw
Washer
8c
Plane sole
V grooves
Fastening screw for the fold depth stop
Fold depth stop
Dial for setting the cut depth (additional handle)
Cut depth scale
Adapter for external extraction
Parking shoe
Cutter block
Clamping element
│ GB │ IE
■ 14
Fastening screw for the planing blade
Planing blade
Tensioning plate groove
20a
Lateral cutter block guard
Hex key
Drive belt
Large belt wheel
Small belt wheel
Open-ended spanner

Package contents

1 electric planer PEH 30 C3
1 guide fence
1 fold depth stop
1 hex key
1 open-ended spanner
1 adapter for external extraction
1 operating manual

Technical data

Rated voltage:
Nominal output:
Rated idle
speed:
Plane width:
Cut depth:
Fold depth:
Protection class:
Noise and vibration data:
Noise measurement value determined in accordance
with EN 62841. The A-rated noise level of the
power tool is typically as follows:
Noise emission value:
Sound pressure level:
Sound power level:
Uncertainty:
230 V ∼ 50 Hz (AC)
750 W
n 13000 rpm
0
82 mm
0–3 mm
max. 24 mm
II / (double insulation)
L = 97 dB(A)
PA
L = 108 dB(A)
WA
K = 3 dB
PEH 30 C3