Interrupting Operation; Ending Operation; Using Detergents; Cleaning And Maintenance - Parkside PHD 110 C1 Originalbetriebsanleitung

GB IE
Bleed the equipment:
5. Switch on the equipment at the on/off
switch (17) until the pressure has built
up.
6. Switch off the equipment at the on/off
switch (17).
7. Depress the start lever on the spray
gun (10) until the pressure is released.
8. Please repeat steps 5. to 7. several
times until there is no further air in the
equipment.

Interrupting operation

• Release the lever of the gun (
• During prolonged work intervals turn
off the washer by its ON / OFF switch
( 17).
A

Ending operation

• After working with cleaning agents,
run the equipment with clean water to
completely rinse the cleaning agent
from the pipes.
• Release the lever of the gun (
• Turn off the pressure by its ON / OFF
switch ( 17).
A
• Turn off the water tap.
• Pull the lever of the gun (
the pressure existing within the system.
• Pull the mains plug and wind up the
mains cable.
• Disconnect the pressure washer from
the water mains.

Using detergents

The washer was designed for operation
with a neutral detergent based on a bio-
logically decomposable anionic tenside.
Other detergents or chemical substances
could impair the safety of the washer and
damage it.
24
Cleaning and

Maintenance

Cleaning

4).
A
Always keep the washer clean. Do
not use any detergents or solvents.
•
•
•
4).
A
4) to vent
A
E
Maintenance
The pressure washer is maintenance free.
Pull out the power plug before
every maintenance operation. There
is a risk of electrocution or of injury
from moving parts.
Never direct the water jet
against the washer, nor clean
the washer under flowing
water. This could give rise to
the danger of electric shock
and damage the washer! .
Always keep the ventilation slots clean
and free.
Only clean the pressure washer with a
soft brush or a slightly moist cloth.
In case a nozzle of the jet
tube ( 11/12) is clogged up, use
A
the nozzle cleaning pin (
move the object from the nozzle.
If necessary, take off the water con-
nection with the filter insert (10)
and clean the filter insert.
Ask our service centre to carry out
any work that is not described in
these instructions. Use only original
parts.
7) to re-
A