When A Problem Occurs - Epson Easy MP Benutzerhandbuch

When a Problem Occurs

The following describes problems that may occur when scenarios or image files are projected and
when EMP SlideMaker is used. Refer to this section when a problem occurs.
No Image Is Projected
"No signal" is displayed.
"No memory card" is
displayed.
"No displayable files" is
displayed.
"No files" is displayed.
50
- When a Problem Occurs
G Check whether or not an EasyMP image has been properly
selected.
Press the [Source] button on the projector's main unit (or the
[EasyMP] button on the remote control) to switch to an EasyMP image.
Refer to "Projecting Scenarios and Files (EasyMP)" (see page 34)
G Check whether or not a memory card is inserted.
Insert a memory card into the card slot (in the projector's main unit).
G Check whether or not files that cannot be displayed are stored in
the memory card.
Files that can be displayed by EasyMP include scenario files (.sit),
JPEG files (.JPG) and bitmap files (.BMP). Other file formats cannot be
used.
* JPEG files with the file extension "JPEG" can be recognized as JPEG files in Windows.
However, they cannot be recognized by EasyMP. Therefore, change the file extension of
JPEG files to "JPG" or "jpg".
G Check whether or not the specified file has been deleted.
If the contents of a memory card have been overwritten from the PC via
a USB connection, the contents of the file list being displayed may
differ from the contents of the memory card. Press the [EasyMP] button
to update the file display.