Circular Saw Warnings - Parkside PHKSAP 20-Li A1 Bedienungs- Und Sicherheitshinweise

Power tool use and care
Do not force the power tool. use
1.
the correct power tool for your
application. The correct power tool will do
the job better and safer at the rate for which it
was designed.
Do not use the power tool if the
2.
switch does not turn it on and off. Any
power tool that cannot be controlled with the
switch is dangerous and must be repaired.
Disconnect the plug from the power
3.
source and/or the battery pack from
the power tool before making any
adjustments, changing accessories,
or storing power tools. Such preventive
safety measures reduce the risk of starting the
power tool accidentally.
Store idle power tools out of the
4.
reach of children and do not allow
persons unfamiliar with the power
tool or these instructions to operate
the power tool. Power tools are
dangerous in the hands of untrained users.
Maintain power tools. Check for
5.
misalignment or binding of moving
parts, breakage of parts and any
other condition that may affect the
power tool's operation. If damaged,
have the power tool repaired before
use. Many accidents are caused by poorly
maintained power tools.
Keep cutting tools sharp and clean.
6.
Properly maintained cutting tools with sharp
cutting edges are less likely to bind and are
easier to control.
use the power tool, accessories
7.
and tool bits etc. in accordance
with these instructions, taking into
account the working conditions and
the work to be performed. Use of the
power tool for operations different from those
intended could result in a hazardous situation.
Battery tool use and care
recharge only with the charger
1.
specified by the manufacturer. A
charger that is suitable for one type of battery
pack may create a risk of fire when used with
another battery pack.
use power tools only with
2.
specifically designated battery
packs. Use of any other battery packs may
create a risk of injury and fire.
When battery pack is not in use,
3.
keep it away from other metal
objects, like paper clips, coins, keys,
nails, screws or other small metal
objects, that can make a connection
from one terminal to another. Shorting
the battery terminals together may cause
burns or a fire.
under abusive conditions, liquid
4.
may be ejected from the battery;
avoid contact. If contact accidentally
occurs, flush with water. If liquid
contacts eyes, additionally seek
medical help. Liquid ejected from the
battery may cause irritation or burns.
Service
Have your power tool serviced by
1.
a qualified repair person using only
identical replacement parts. This will
ensure that the safety of the power tool is
maintained.

Circular saw warnings

Q
Safety instructions for all saws – Cutting
procedures
DANGer! Keep hands away from
1.
cutting area and the blade. Keep
your second hand on auxiliary
handle, or motor housing. If both hands
are holding the saw, they cannot be cut by
the blade.
Do not reach underneath the
2.
workpiece. The guard cannot protect you
from the blade below the workpiece.
Adjust the cutting depth to the
3.
thickness of the workpiece. Less than a
full tooth of the blade teeth should be visible
below the workpiece.
Never hold piece being cut in your
4.
hands or across your leg. Secure the
workpiece to a stable platform. It is
important to support the work properly to
minimise body exposure, blade binding, or
loss of control.
Hold the power tool by insulated
5.
gripping surfaces only, when
performing an operation where
the cutting tool may contact hidden
wiring. Contact with a "live" wire will also
make exposed metal parts of the power tool
"live" and could give the operator an electric
shock.
GB / IE / NI 9