Commissioning; Shutting Down; Environmental Protection/Disposal; Maintenance - Buderus Logalux PR 750 Installations- Und Wartungsanleitung

6

Commissioning

NOTE: Risk of material damage due to
incorrectly set pressure on the heating water
side.
B Observe maximum permissible values
( Table 31, page 28 and Table 33,
page 28).
Commissioning must only be carried out by the heating
system installer or an authorised contractor.
B Check all connections for leaks.
B Commission the heating system – observe the
installation and operating instructions of the control
unit, heat source and solar thermal system.
7

Shutting down

DANGER: Risk of scalding through hot
water.
B Allow the buffer cylinder time to cool down
sufficiently after being shut down.
NOTE: Cylinder damage through frost.
If there is a risk of frost, we recommend
leaving the buffer cylinder operational or
shutting it down and draining it.
B Shutting down the heating system – observe the
installation and operating instructions of the control
unit, heat source and solar thermal system.
B Open the system drain valve.
B Open the air vent valve to vent.
B Fully drain the buffer cylinder and dry the inside.
Logalux – 6 720 648 089 (2011/10)
8 Environmental protection/
disposal
Environmental protection is one of the fundamental
company policies of the Bosch Group.
Quality of products, efficiency and environmental
protection are equally important objectives for us. All
legislation pertaining to the environment is strictly
observed. To protect the environment we use the best
possible technology and materials, subject to economics.
Packaging
We are dedicated in adhering to country-specific disposal
standards as they relate to packaging to ensure optimum
recycling. All packaging materials are environmentally
compatible and can be recycled.
Used appliances
Old appliances contain materials that should be recycled.
The relevant assemblies are easy to separate, and all
plastics are identified. This allows the various assemblies
to be appropriately sorted for recycling or disposal.
9

Maintenance

The buffer vessel has to be maintained in accordance with
local standards. In addition the buffer needs to be visually
inspected.
B Check all connections externally for leaks once a year.
Contact an authorised contractor or customer service
and notify them of the fault as well as the appliance
details.
6
Commissioning
31