Error, Faults & Troubleshooting; Maintenance And Cleaning - Parkside 20 M PLEM 20 A1 Bedienungs- Und Sicherheitshinweise

If needed to measure another distance, repeat above steps.
Newly measured value will be shown on the bottom line of
the display and the previous measured value will be shown
in the middle of the display. Now, the laser beam will be
turned off.
Error, faults & troubleshooting
Faults Cause
----- Calculation error
301 Operating temperature
too low or too high
401 Hardware failure

Maintenance and Cleaning

The product is maintenance-free.
CAUTION! Never submerse the product in water or other
liquids. Do not allow any moisture to penetrate into the
product during cleaning.
Clean the laser beam output opening
lens with a gentle air stream. In the case of more
1
28 GB/IE
Solution
Pay attention to the
correct operating
measuring range.
Pay attention to the
correct operating
temperature range
(0 °–40 °C).
If the icon appears de-
spite repeated switching on
and off, take the product
to a specialist workshop
and the receiver
2