Herunterladen Inhalt Inhalt Diese Seite drucken

Troubleshooting; Service Information; Possible Cause - Parkside PZKS 2000 A1 Bedienungs- Und Sicherheitshinweise Originalbetriebsanleitung

Kapp- und zugsäge
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen
  • DE

Verfügbare Sprachen

  • DEUTSCH, seite 1
The packaging is wholly composed of environment ally-friendly materials that can be disposed of at a local recycling
centre.
Contact your local refuse disposal authority for more details of how to dispose of your worn-out electrical devices.
Old devices must not be disposed of with household waste!
This symbol indicates that this product must not be disposed of together with domestic waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and electronic equipment (WEEE). This product must be disposed of at a designat-
ed collection point. This can occur, for example, by handing it in at an authorised collecting point for the recycling of waste electri-
cal and electronic equipment. Improper handling of waste equipment may have negative consequences for the environment and
human health due to potentially hazardous substances that are often contained in electrical and electronic equipment. By properly
disposing of this product, you are also contributing to the effective use of natural resources. You can obtain information on collection
points for waste equipment from your municipal administration, public waste disposal authority, an authorised body for the disposal of
waste electrical and electronic equipment or your waste disposal company.

14. Troubleshooting

Fault

Possible cause

Motor does not work
Motor, cable or plug defective, fuses burnt
The motor starts up slowly
Voltage too low, coils damaged, capacitor burnt
and does not reach oper-
ating speed.
Motor makes excessive
Coils damaged, motor defective
noise
The motor does not reach
Circuits in the network are overloaded (lamps,
its full power.
other motors, etc.)
Motor overheats easily.
Overloading of the motor, insufficient cooling of
the motor
Saw cut is rough or wavy
Saw blade dull, tooth shape not appropriate for
the material thickness
Workpiece pulls away
Excessive cutting pressure and/or saw blade not
and/or splinters
suitable for use

Service information

Please note that the following parts of this product are subject to normal or natural wear and that the following parts are therefore also required
for use as consumables.
Wear parts*: carbon brushes, saw blade, table inserts, sawdust bags
* Not necessarily included in the scope of delivery!
Remedy
Arrange for inspection of the machine by a specialist.
Never repair the motor yourself. Danger!
Check fuses and replace as necessary
Contact the utility provider to check the voltage.
Arrange for inspection of the motor by a specialist. Ar-
range for replacement of the capacitor by a specialist
Arrange for inspection of the motor by a specialist
Do not use any other equipment or motors on the same
circuit
Avoid overloading the motor while cutting, remove dust
from the motor in order to ensure optimal cooling of the
motor
Re-sharpen saw blade and/or use suitable saw blade
Insert suitable saw blade
GB/IE
27

Quicklinks ausblenden:

Werbung

Inhaltsverzeichnis
loading

Inhaltsverzeichnis