GB
IE
Vertical cut / lawn edge
trimming
Be particularly careful and
attentive when operating the
cutter vertically. To avoid in-
juries, keep enough distance
to the trimming assembly.
Setup for vertical trimming:
Move the appliance to the right and
left in a slow swinging motion to
trim slopes and steep inclines.
• Handle rod: 180° (see
• Cutting angle: 0° (see
• Spacer bow in parking position
Setup for edge trimming:
To trim lawn edges, slowly move
the appliance along the lawn edg-
es.
• Handle rod: 90° (see
• Cutting angle: 90° (see
• Spacer bow in parking position
Cleaning and
maintenance
Warning! Risk of injury from
moving dangerous parts!
Contact our Service Centre about
repairs and servicing not described
in this manual. Only use OEM
parts. Risk of injury!
Turn off the appliance and, before
doing any servicing, remove the
battery.
The following cleaning and servicing
should be done regularly. This will ensure
a long and reliable service life.
30
Cleaning
•
Keep clean the ventilation slots, motor
housing and handles of the appliance.
Use a damp cloth or a brush. Do not
use cleaning agents or solvents. You
may otherwise irreparably damage the
appliance.
•
After every trimming session, remove
)
grass and soil from the protective cover
)
and the trimming assembly.
•
To thoroughly clean the trimming as-
sembly, remove the cutting insert
(
insert") and use a sharp knife to clean
the pin (
)
General maintenance
)
•
Prior to every use, check the appliance
for obvious defects such as loose, worn
or damaged parts. Check that the
screws in the cutting disk are tight.
•
Check covers and safety devices for
damages and correct installation. Re-
place as necessary.
Replacing the cutting insert
1. Slide the cutting insert (13) in-
2. Place the new cutting insert (13)
Do not spray the appliance
with water and do not im-
merse it in water. Electric
shock hazard!
13) (see "Replacing the cutting
22).
ward and push it out of the pin
(23) on the cutting disk (12).
on the pin (23) and pull out the
insert until it snaps in.