Husqvarna AUTOMOWER 305 Bedienungsanleitung Seite 38

Never lift up the robotic lawnmower or carry it around when the main
switch is in position 1.
Do not let persons who do not know how the robotic lawnmower works
and behaves use it.
Never use the robotic lawnmower if persons, especially children, or pets,
are in the immediate vicinity.
Do not put anything on top of the robotic lawnmower or its charging sta-
tion.
Do not allow the robotic lawnmower to be used with a defective blade
disc or body. Neither should it be used with defective blades, screws,
nuts or wires.
Do not use the robotic lawnmower if the main switch does not work.
Always switch off the robotic lawnmower using the main switch when the
robotic lawnmower is not in use. The robotic lawnmower can only start
when the main switch is set to 1 and the correct PIN code has been ente-
red.
The robotic lawnmower must never be used at the same time as a
sprinkler. In this case use the timer function so the mower and sprinkler
never run simultaneously.
Husqvarna AB does not guarantee full compatibility between the robotic
lawnmower and other types of wireless systems such as remote con-
trols, radio transmitters, hearing loops, underground electric animal fen-
cing or similar.
Connecting the transformer
Take the following into consideration when planning where to place the
transformer:
• Close to the charging station
• Protection from rain
• Protection from direct sunlight
If the transformer is connected to an electrical socket outdoors, this
must be approved for outdoor use. It is recommended to use an earth
fault-breaker when connecting the transformer to the wall socket.
The low voltage cable must not under any circumstances be shortened
or extended. Place the low voltage cable so that the blades on the blade
disc can never come in contact with it.
Do not, under any circumstances, mount the transformer at a height
where there is a risk it can be submerged in water (at least 30 cm from
the ground). It is not permitted to place the transformer on the ground.
Transport
The original packaging should be used when transporting the robotic
lawnmower over long distances.
To safely move from or within the working area:
1. Press the STOP button to stop the robotic lawnmower. If security is
set to the medium or high level, the PIN code has to be entered.
The PIN code has four digits and is chosen when the robotic
lawnmower is started for the first time.
English - 38
ENGLISH
2. Set the main switch to position 0.
Automower 305/308
3. Carry the robotic lawnmower by the handle with the blade disc
away from the body.
Automower 305/308
IMPORTANT INFORMATION
Do not lift the robotic lawnmower when it is parked in the
charging station. It can damage the charging station and/
or the robotic lawnmower. Press STOP and instead first pull
the robotic lawnmower out of the charging station before
lifting it.
Maintenance
WARNING
When the robotic lawnmower is turned upside
down the main switch must always be in the 0
position.
The main switch should be set in the 0 position
during all work on the mower's chassis, such as
cleaning or replacing the blades.
Inspect the robotic lawnmower each week and replace any damaged or
worn parts. The following must be carried out in the weekly inspections:
1. Clean the charging station from grass, leaves, twigs and other
objects that may impede the robotic lawnmower from docking with
the charging station.
2. Set the main switch to position 0 and put on a pair of protective
gloves.
3. Turn the robotic lawnmower upside down. Check the following:
• Clean the wheels and axles. Grass
ence operation on slopes.
• Clean the body, chassis and cutting system. Grass, leaves and
other objects that weigh down the product affect performance.
• Check that all mower blades are intact. Check also that the
mower blades can pivot freely. Even if the mower blades are
intact, they must be replaced on a regular basis for the best
mowing result and low energy usage. Replace all blades and
screws at the same time if necessary so that the rotating parts
are kept balanced.
WARNING
Always use original blades and screws when repla-
cing. Only replacing the blades and reusing the
screw can result in a screw wearing during mowing
and shearing. The blades can then be propelled
from under the body and cause serious injury.
Automower 320/330X
Automower 320/330X
on the drive wheels can influ-