Technical Data - Parkside PDMH 4500 A1 Bedienungs- Und Sicherheitshinweise

Anleitung_LB3_4139032:_
GB/
IE
Please note that our equipment has not been
designed for use in commercial, trade or
industrial applications. Our warranty will be
voided if the equipment is used in commercial,
trade or industrial businesses or for equivalent
purposes.
Only allow repairs and services to be carried
out by authorized professional repair shops.
Remember.
Too small a diameter of the hose and too
long a hose line will result in loss of power.

6. Technical data

Max. permitted operating pressure:
Air consumption at 4.0/6.3 bar:
Chisel mounting (hexagon):
Stroke:
Blow rate:
Recommended hose diameter:
Weight:
Sound and vibration
Sound and vibration values were measured in
accordance with ISO 15744 and ISO 28927-10.
L sound pressure level
pA
K uncertainty
pA
L sound power level
WA
K uncertainty
WA
Wear ear-muffs.
The impact of noise can cause damage to
hearing.
Vibrations
Vibration emission value a
K uncertainty = 1.4 m/s 2
10
13.04.2011 13:16 Uhr
Additional information
Warning!
The specified vibration value was established in
accordance with a standardized testing
method. It may change according to how the
equipment is used and may exceed the
specified value in exceptional circumstances.
The specified vibration value can be used to
compare the equipment with another tool.
The specified vibration value can be used for
initial assessment of a harmful effect.
Reduce noise generation and vibration to a
minimum!
■
6.3 bar
160/280 l/min
■
■
9.8 mm
44 mm
■
4,500 min -1
■
Ø 10 mm
■
■
1.0 kg
Residual risks
Even if you use the equipment in
accordance with the instructions, certain
residual risks cannot be eliminated. The
following hazards may arise in connection
with the equipment's construction and
layout:
1. Lung damage if no suitable protective dust
84 dB(A)
3 dB
2. Damage to hearing if no suitable ear
95.2 dB(A)
3 dB 3. Health damage caused by hand-arm
Air supply:
Via a compressed air source with pressure
setting function, e.g. a compressor. Before
= 9.5 m/s 2
hd
starting up, please also read section 8 "Care
and maintenance".
Seite 10
Use only equipment that is in perfect
condition.
Maintain and clean the equipment regularly.
Adopt your way of working to the
equipment.
Do not overload the equipment.
Have the equipment checked if necessary.
Switch off the equipment when not in use.
Wear gloves.
mask is used.
protection is used.
vibrations if the equipment is used over a
longer period or is not properly guided and
maintained.