Storage; Transport; Ordering Spare Parts; Recycling - Parkside PGI 1200 A1 Bedienungs- Und Sicherheitshinweise

Note: alternative spark plugs to
Bosch UR3AC
Petrol filter (Fig. 7)
Note: The petrol filter (18) is a filter bowl located di-
rectly under the petrol cap (2) , filtering any petrol
added.
• Turn the on /o ff switch (6) to the "OFF" position.
• Open the petrol cap (2)
• Remove the petrol filter 5 and clean in a nonflam-
mable solvent or solvent with a high tlash point.
• Reinsert petrol filter
• Close the petrol cap (2)
Changing the oil, (Fig. 5)
Changing the oil should take place when the engine
is warm.
WARNING! Drain fuel before replacing the oil.
Only use engine oil (15 W-40).
• Place the generator on its front side on a suitable
surface.
• Open the oil filler cap (13) and drain the warm en-
gine oil into a container by tilting the generator.
• Pour in engine oil (approx. 0.25 litres).
• Stand the generator upright again.
Low oil switch off
The low oil switch-off responds, if there is not enough
engine oil. The oil check bulb (5) starts to flash when
there is insufficient oil in the motor. The check bulb
begins to flash when the oil amount has gone below
the safe level. The engine will turn off independently
after a short time. Restart is possible only after pour-
ing in more engine oil (see Chapter "Replacing the
oil").

9. Storage

Preparation for storage
• Empty the petrol tank with a petrol suction pump.
Warning notice: Do not remove fuel in closed
rooms, close to fire or whilst smoking. Vapours can
cause explosions or fires.
• Start the engine and leave it running until the rest of
the petrol has been used up.
• Change the oil after each season. To do this, re-
move the old oil from the warm engine and refill
with new oil.
• Remove the spark plug. Fill about 20 ml of oil into
the cylinder using an oil can.
• Slowly pull the express start so that the oil protects
the cylinder from the inside.
• Screw the spark plug back in
• Store the device in a well ventilated place or area.

10. Transport

Preparation for transporting
• Empty the petrol tank with a petrol suction pump
or alternatively using the petrol tap and a suitable
canister.
6 GB/IE/NI
• Once it it ready for use, leave the engine running
until the rest of the petrol has been used up.
• Empty the engine oil from the engine (as described).
• Remove the spark plug connector from the spark
plug.
• Secure the device with a tension belt to prevent it
slipping out of place.

11. Ordering spare parts

When ordering replacement parts you should give
the following information:
• Type of device
• Device article number

12. Recycling

The packaging is made of environmentally friendly
materials. It can be disposed of at your local recycling
centre.
Old devices must not be disposed of with
household waste!
This symbol indicates that this product must
not be disposed of together with domestic
waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical
and electronic equipment (WEEE). This
product must be disposed of at a designated collec-
tion point. This can occur, for example, by handing it
in at an authorised collecting point for the recycling
of waste electrical and electronic equipment. Improp-
er handling of waste equipment may have negative
consequences for the environment and human
health due to potentially hazardous substances that
are often contained in electrical and electronic equip-
ment. By properly disposing of this product, you are
also contributing to the effective use of natural re-
sources. You can obtain information on collection
points for waste equipment from your municipal ad-
ministration, public waste disposal authority, an au-
thorised body for the disposal of waste electrical and
electronic equipment or your waste disposal com-
pany.
Environmental protection
Take any contaminated maintenance material and
operating materials to a collection point designated
for this purpose.
When disposing of residual fluids (oils and fuel), ob-
serve the corresponding environmental regulations.
We recommend taking all remaining operating mate-
rials to your local collection point in a suitable sealed
container. Do not pour the remaining operating ma-
terials into waste or on the ground.