Technical Data; Technical Specifications; Troubleshooting - Grundig RR 316 series Bedienungsanleitung

TECHNICAL DATA

Technical specifications

Power Supply
Mains operation ..............230 Volt, 50/60 Hz
Battery operation ...........6 x 1.5 V (R20, UM1)
Output power DIN 45324, 10% THD
Music power: ...................AC: 2 x 1500 mW
Nominal power .................DC 2 x 1000 mW
......................................AC: 2 x 1000 mW
Jack socket for stereo headphones:....3.5 mm ø
Radio section
Wavebands: .................FM 87.5 – 108 MHz
...........................MW 526.5 – 1606.5 kHz
............LW 148.5 – 283.5 kHz (for RR 316 L)
Antennas: ...................Telescopic aerial for FM
.......Built in ferrite rod aerial for AM/MW (LW)
Cassette section
Cassette:........Compact cassette to DIN 45516
Track system: ..............International quartertrack
Tape speed:.............................4.76 cm/sec.
Motor: ...........................................DC motor
Frequency range: ...............125 Hz – 6.3 kHz
S/N ratio, weighted ............................45 dB
Wow and flutter: ................................ 0.35%
Automatic functions:
.....................Automatic recording level control
...............Automatic button release at tape end
Subject to technical alterations and alterations
in styling E. and O.E.

TROUBLESHOOTING

If a fault occurs, first check the points listed below before taking the set for repair.
If you are unable to remedy a problem by following these hints, consult your dealer or service centre.
WARNING: Under no circumstances should you try to repair the set yourself, as this would invalidate
the guarantee.
PROBLEM POSSIBLE CAUSE
No sound VOLUME is not adjusted
Headphones are connected
Batteries are exhausted
Batteries are incorrectly inserted
Mains lead is not securely connected
Poor radio Weak radio aerial signal
reception
Interference caused by the vicinity of
electrical equipment like TVs, video
recorders, computers, thermostats,
fluorescent lamps (TL), engines etc.
Poor cassette Dust and dirt on the heads, capstan
sound quality or pressure roller
Recording does Cassette tab(s) may be broken out
not work
This unit meets the CEE regulations concerning interference radiation.
This product fulfills European directives 89/336/EEC, 73/23/EEC and 93/68/EEC.
This unit complies with the safety regulations according to VDE 0860 / BS 415 and thus with the
international safety regulation according to IEC 65.
The type plate is located on the back of the set
REMEDY
Adjust the VOLUME
Disconnect headphones
Insert fresh batteries
Insert the batteries correctly
Connect the mains lead properly
Aim the aerial for best reception:
FM: incline and rotate telescopic aerial
AM/MW (LW): rotate the entire set
Keep the radio away from electrical
equipment
Clean the heads etc., see Maintenance
Apply a piece of adhesive tape over the
missing tab space
GB
11