Wired Network Setup - Pioneer BCS-414 Bedienungsanleitung

28 Connecting

Wired Network Setup

If there is a DHCP server on the local area network
(LAN) via wired connection, this player will
automatically be allocated an IP address. After
making the physical connection, a small number of
home networks may require the player's network
setting to be adjusted. Adjust the [NETWORK]
setting as follow.
2 Preparation
Before setting the wired network, you need to
connect the broadband internet to your home
network.
1. Select [Connection Setting] option in the
[Setup] menu then press ENTER (b).
2. Use W/S/A/D to select the IP mode
between [Dynamic] and [Static].
Normally, select [Dynamic] to allocate an IP
address automatically.
, ,
Note
If there is no DHCP server on the network and
you want to set the IP address manually, select
[Static] then set [IP Address], [Subnet Mask],
[Gateway] and [DNS Server] using W/S/
A/D and numerical buttons. If you make a
mistake while entering a number, press CLEAR
to clear the highlighted part.
3. Select [OK] and press ENTER (b) to apply
network settings.
4. The player will ask you to test the network
connection. Select [OK] and press ENTER (b) to
complete the network connection.
5. If you select [Test] and press ENTER (b) at
step 4 above, the network connection status is
displayed on the screen.
You can also test it on the [Connection Status]
in the [Setup] menu.