Cycling Computer Operations; Assist Mode - Blaupunkt CLARA 390 Bedienungsanleitung

8. CYCLING COMPUTER OPERATIONS

LC- CONTROL DISPLAY
The control unit is integrated with the LC-
Display and operates the drive system. It is
located on the handlebar.
Control Unit Function Overview
1.1 Power Button ON/ OFF
Hold button for 2 seconds to switch
on/off the LED control unit and electric drive
system.
The system will automatically turn off if left
idling for more than 10 minutes.

1.2 Assist mode

Hold or buttons to select the
desired assist level for electric system. The
lowest is Level 1 and the highest is Level 5.
When powered on, the default is Level 1.
When there is no numeric power level
displayed it means the e-bike is in park or it
functions as a standard bike with no assist
from the motor. You will feel the electric
assistance kicking in once selecting again
between Levels 1 up to 5.
1.3 Lights/ Backlit Button ON/ OFF
With the display switched on, hold the
button for 2 seconds to turn on/ off the
headlight, taillight and the display backlight.
There are five levels of backlight brightness
that can be selected by user.
1.4 Walk Assist
The e-bike comes equipped with walk assist
function. This feature propels forward your
e-bike with a constant speed of 6km/h
without pedaling and requires nothing but
to hold it balanced when walking along side
it. It comes very handy when needing to
push it up a steep incline.
Hold the button to activate the walk
assist. This function remains activated as
long as you hold the
deactivates the moment you stop holding it.
SAFETY NOTE: Push Assist function should only
be used when the wheels are in contact with
the ground. Danger of injury may occur if push
assist function is activated since the rear wheel
will start spinning.
button and