Honeywell KaltecSoft PW50AS Einbauanleitung Seite 19

Disturbance
No brine intake
Permanent discharge into
sewerage tube
High salt consumption
No or insufficient salt con-
sumption
Saline water
Differential pressure at the
device is too high
Honeywell GmbH
Cause
Incorrect settings at the control valve
Sewerage tube is blocked
Min. operating pressure not available
Back pressure in sewerage tube is too high
Control head is defective
Incorrect settings at the control valve
Blending has been set incorrectly
Too much water in the storage tank
Incorrect settings at the control valve
Blending has been set incorrectly
Brine tube is contaminated
Min. operating pressure not available
Incorrect settings at the control valve
Brine valve is contaminated or defective
Control head is defective
Construction of the device is too small
Blending has been closed too widely
Pressure water supply is not smooth
GB
Remedy
Check the control valve settings
( Chapter 9)
Clean and, if necessary, replace sewerage tube
(CS)
Min. operating pressure is 1.8 bar
( Chapter 3)
Clean and, if necessary, replace sewerage tube
(CS)
Call the Technical Customer Service on
(49) 6261 810
Check the control valve settings
( Chapter 9)
Check blending valve and mixing ratio
( Chapter 7.8)
Fault “"too much water in the storage tank”"
Check the control valve settings
(Chapter 9. )
Check blending valve and mixing ratio
( Chapter 7.8)
Clean brine tube
Min. operating pressure is 1.8 bar
( Chapter 3)
Check the control valve settings
( Chapter 9)
Clean and, if necessary, replace brine valve
1
(CS)
Call the Technical Customer Service on
(49) 6261 810
Call the Technical Customer Service on
(49) 6261 810
Check blending and mixing ratio
Check functioning of the pressure reducer in
front of the device
Install pressure reducer in front of the device
( Chapter 6.1)
19
1. CS = Customer Service
MU1H-1408GE23 R0305