Light level required for activation [LUX]
•
The sensor has a photocell that detects various degrees of light and darkness.
Adjust the sensitivity by turning the [LUX] screw towards
•
The Sun mode will set the light to operate in daylight to dusk; the Moon mode will
set the light to operate from dusk to darkness.
Batteries
Changing the batteries
1. Remove the screws in the top of
the light and lift it off.
3. Change the batteries.
4. Note the polarity markings in the battery compartment to ensure correct insertion.
5. Only use rechargeable NiMH batteries (3 × AA/HR6).
6. Replace the cover on the battery compartment.
7. Refit the top of the solar light and fasten it using the two screws.
Care and maintenance
Clean the solar light using a lightly moistened cloth. Only use mild cleaning agents,
never solvents or corrosive chemicals.
Troubleshooting guide
The wall light doesn't
come on.
The wall light comes
on inadvertently.
2. Press down the two catches and
•
Make sure that [AUTO/OFF] is set to AUTO.
•
The batteries are flat. Recharge or replace the batteries.
•
The cable connecting the solar cell to the solar light
is damaged.
•
See the Placement section above.
6
or .
remove the battery cover.