Further Safety Instructions; Δήλωσης Συμμόρφωσης Ce - Parkside PSS 65 A1 Originalbetriebsanleitung

G B
changing accessories.
- Inspect tool cords periodically and if
damaged have them repaired by an
authorized service facility.
- Inspect extension cords periodically
and replace if damaged.
- Keep handles dry, clean and free
from oil and grease.
Disconnect tools. When not in use,
•
before servicing and when changing
accessories disconnect tools from the
power supply.
Such preventive safety measures reduce
the risk of starting the power tool acci-
dentaIly.
Remove adjusting keys and
•
wrenches. Form the habit of check-
ing to see that keys and adjusting
wrenches are removed from the tool
before turning it on. A wrench or a key
left attached to a rotating part of the
power tool may result in personal injury.
Avoid unintentional starting.
•
Ensure switch is in "off" position when
plugging in.
Use outdoor extension leads.
•
When the tool is used outdoors, use
only extension cords intended for out-
door use and so marked.
Stay alert, watch what you are
•
doing and use common sense
when operating a power tool.
Do not use a power tool while you are
tired or under the influence of drugs,
alcohol or medication. A moment of
inattention white operating power tools
may result in serious personal injury.
Check damaged parts. This will
•
ensure that the safety of the power tool
is maintained.
- Before further use of tool, it should be
carefully checked to determine that it
will operate properly and perform its
intended function.
8
- Check for alignment of moving parts,
binding of moving parts, breakage of
parts, mounting and any other condi-
tions that may affect its operation.
- A guard or other part that is dam-
aged should be properly repaired or
replaced by an authorized service
centre unless otherwise indicated in
this instruction manual.
- Have defective switches replaced by
an authorized service centre.
- Do not use the tool if the switch does
not turn it on and off.
There is a risk of injury.
Warning.
•
The use of any accessory or attach-
ment other than one recommended in
this instruction manual may present a
risk of personal injury.
Have your tool repaired by a
•
qualified person. This electric tool
complies with the relevant safety rules.
Repairs should only be carried out by
qualified persons using original spare
parts, otherwise this may result in con-
siderable danger to the user..

Further Safety Instructions

• Connect the device only to a power
point with a residual current protective
device (RCD) with a measured residual
current of not more than 30 mA.
• Keep the mains cable and extension
cable away from the grinding disk and
saw chain. In the event that it is dam-
aged or severed, immediately discon-
nect the plug from the socket.
Do not touch the cable before it has
been disconnected from the mains.
Risk of electric shock.
• The replacement of the plug or the con-
nection line must always be executed
by the manufacturer of the electric tool