Adjusting The Paint Jet; Regulating The Quantity Of Paint; Regulating The Quantity Of Air; Maintenance And Cleaning - Parkside PDFP 500 A1 Originalbetriebsanleitung

- When working with the device you should open
the vent .
1
- When diluting the material, make sure that the
spraying material and the dilution are suitable
for one another. If an incorrect dilution is used,
lumps may form and clog the gun as a result.
- Screw the flow cup
the gun.
- Fill the spraying material into the flow cup
and screw the lid
2
- Always hold the paint spray gun at the same
distance from the object. The ideal spraying
distance is approximately 15 cm.
- Determine the appropriate settings in each
case by experimenting.
- Do not turn the device on / off when it is over the
spraying surface, but start and end the spraying
process approximately 10 cm outside of the
spraying area.
P ress the trigger
8
it held down.
I n order to stop spraying, release the trigger
again.

Adjusting the paint jet

Q
The device has the settings round and broad jet.
Round jet Broad jet
Adjusting the round jet:
U se the round jet, for example, for small surfaces,
corners and edges.
T urn the regulator
5
Adjusting the broad jet:
U se the broad jet vertically and horizontally
over larger areas.
T urn the regulator
5
tion . The nozzle head
adjusted vertically and horizontally by turning
to the desired position.
clockwise firmly on to
3
3
on tight.
to start spraying and keep
in a clockwise direction
in an anticlockwise direc-
can be continuously
9
Initial use / Maintenance and Cleaning
Regulating the
Q
quantity of paint
Note: The front locking screw is used to limit the
adjustment range of the stroke stop screw
Increasing the quantity of paint:
T urn the stroke stop screw
direction.
Reducing the quantity of paint:
T urn the stroke stop screw
direction.

Regulating the quantity of air

Q
Note: It is advisable to start with the maximum
amount of air. In order to do this, open the air volume
regulator as described below under "Increas-
7
ing the air quantity" up to the maximum setting.
Increasing the air quantity:
8
Note: Increasing the amount of air is generally
advisable when the degree of atomization is too
coarse.
T urn the air quantity regulator
clockwise direction.
Reducing the air quantity:
Note: Reducing the amount of air is generally
advisable when the paint spray is too strong.
T urn the air quantity regulator
wise direction.

Maintenance and Cleaning

Note: Thorough cleaning after each use is very
.
important for safety and operation. Otherwise, for
example, the needle will become clogged and the
proper functioning of the appliance can no longer
be guaranteed.
Wear suitable protective gloves when carrying
out cleaning work.
Do not use any hydrocarbon-containing halogen
solvents, such as trichloromethyl, ethyl chloride,
etc., as they undergo chemical reactions with
.
4
in an anticlockwise
4
in a clockwise
4
in an anti-
7
in a clock-
7
GB 41