Attaching The Protective Cover; Mounting The Parallel Stop; Setting Up - Parkside PFSM 500 A1 Originalbetriebsanleitung

3. Remove the protective cover of the
cutting disc (18). In order to do this,
pull the protective cover of the cutting
disc (18) towards the back and tilt it
to one side. You can remove the pro-
tective cover of the cutting disc (18)
by pulling it upwards out of the water
tank.
4. Release the shaft nut (17).
5. Remove the nut (17) and the pressure
disc (16) from the shaft (13). The
mounting flange (14) remains on the
shaft (13).
6. Place the full-rim diamond cutting disc
(15) on the shaft (13). Please note the
direction of rotation. This is marked on
the full-rim diamond cutting disc (15)
and on the protective cover (3).
7. Push the pressure disc (16) with the
straight side against the full-rim dia-
mond cutting disc (15).
8. Turn the shaft nut (17) using wrenches
(1) and (2) to block the shaft (13). First
attach wrench (1) and then wrench
(2).
9. Attach the protective cover of the cut-
ting disc (18) again. Insert the protec-
tive cover of the cutting disc (18) into
the floor guide of the water tank. Press
the protective cover of the cutting disc
(18) on the left and push the protecti-
ve cover back as far as it will go.
10. Reinsert the folding work
surface ( 4).
A cutting disc whose maximum
speed is lower than the nomi-
nal speed of the machine must
not be used.

Attaching the protective cover

1. Remove the screw (23) from the de-
vice.
2. Place the angle bracket (22) in line
behind the full-rim diamond cutting
disc (15) through the mounting hole.
3. Use the screw (23) to attach the retai-
ning bracket (22) to the device.
4. Align the angle bracket (22) with the
full-rim diamond cutting disc (15).
5. Push the protective cover (20) on to
the retaining bracket (22).
6. Screw the protective cover (20) on to
the retaining bracket (22). For this, use
the screw with the star grip (21) and
the nut (19).
The protective cover (3) can-
not be rigidly fixed in place. It
simply lies on top of the work
surface.

Mounting the parallel stop

1. Insert the parallel stop (9) into the
guide mechanism of the device at one
end.
2. Pull the guide clamp of the parallel
stop (9) in order to be able to insert
the guide mechanism on the opposite
side.
3. Attach the two screws with a star grip
to both ends of the parallel stop (9) in
order to be able to clamp the parallel
stop into place.
4. Clamp the parallel stop (9) firmly in
place with the two screws with a star
grip.

Setting up

• The device must only be used on a flat
and stable surface.
• The carrying handle is used exclusively
for transporting the device. The device
can be moved from place to place, but
must not be carried during operation.
GB
37