Before Using For The First Time; Setting Up And Connecting The Coffee Machine; Filling With Water - AEG Electrolux CF 2 Serie Gebrauchsanweisung

g
Never open or repair the coffee
machine. Faulty repairs can result in
considerable hazard to the user.
Repairs to electrical appliances must be
carried out only by qualified service
engineers.
If a repair becomes necessary – includ-
ing replacement of the mains lead,
please contact
• the dealer where you bought the cof-
fee machine, or
• an AEG Customer Service Centre.
If the coffee machine is used incor-
rectly, or for a purpose other than its
intended purpose, we cannot accept
any liability for damage caused or
any guarantee claims. This provision
also applies if the cleaning and des-
caling programs are not run in accor-
dance with the instructions in this
manual, immediately after illumina-
tion of the "Clean" key (Fig. 3, f) or
the "Descale" key (Fig. 3, e).
30
2 Before Using for the First
Time
2.1 Setting Up and Connecting the
Coffee Machine
Choose a suitable, horizontal, stable,
unheated, dry base. Ensure good air
circulation.
Important! If the coffee machine is
brought into a warm room from a cold
environment, wait about two hours
before switching on!
We advise you to place the coffee
machine on a suitable mat to prevent
damage being caused by spray and
splashes.
0 Hold the bean container with the
marking on the "Unlockcontainer"
position,
The bottom opening of the bean con-
tainer must be closed (Fig. 4,a). If it is
not closed (Fig. 4,b), insert the tip of a
ballpoint pen in the small oval hole
(arrow), and turn to close the opening.
0 Now turn the bean container anti-
clockwise to one of the two other posi-
tions.
0 Push the drip tray in, until it engages
on the right under the water tank
(Fig. 5).
0 Plug the coffee machine into an
earthed mains socket. Do not use a
socket that is not earthed!
0 If you do not need the full length of
the mains lead, open the cable com-
partment on the back of the coffee
machine, and tidy away the unused
lead (Fig. 6).
2.2

Filling with Water

Before each time you switch on the
coffee machine, check that there is
water in the water tank. The coffee
machine requires water for the auto-
matic flushing processes each time the
machine is switched on or off.
0 Remove the water tank from the cof-
fee machine (Fig. 7).
and set it in place (Fig. 4).