Power Tool Use And Care; Service; Additional Safety Instructions For Grinders And Polishers; Additional Safety Instructions For Routers - Parkside PSFS 250 A1 Originalbetriebsanleitung

c) Prevent unintentional starting. Ensure the switch
GB
is in the off-position before connecting to power
CY
source and/or battery pack, picking up or
carrying the tool. Carrying power tools with
your finger on the switch or energising power
tools that have the switch on invites accidents.
d) Remove any adjusting key or wrench before
turning the power tool on. A wrench or a key
left attached to a rotating part of the power tool
may result in personal injury.
e) Do not overreach. Keep proper footing and
balance at all times. This enables better control
of the power tool in unexpected situations.
f) Wear suitable clothing. Do not wear loose
clothing or jewellery. Keep your hair, clothing
and gloves away from moving parts. Loose
clothes, jewellery or long hair can be caught in
moving parts.
g) If devices are provided for the connection of
dust extraction and collection facilities, ensure
these are connected and properly used.
Use of dust collection can reduce dust-related
hazards.

4. Power tool use and care

a) Do not overload the power tool. Use the
correct power tool for your application. The
correct power tool will do the job better and
safer at the rate for which it was designed.
b) Do not use the power tool if the switch is defec-
tive. Any power tool that cannot be controlled
with the switch is dangerous and must be re-
paired.
c) Disconnect the plug from the power source
and/or the battery pack from the power tool
before making any adjustments, changing
accessories, or storing power tools. Such
preventive safety measures reduce the risk of
starting the power tool accidentally.
d) Store idle power tools out of the reach of
children. Do not allow persons unfamiliar
with the power tool or these instructions to
operate the power tool. Power tools are
dangerous in the hands of untrained users.
4
e) Maintain power tools with care. Check for
misalignment or binding of moving parts,
breakage of parts and any other condition
that may affect the power tool's operation.
If damaged, have the power tool repaired
before use. Many accidents are caused by
poorly maintained power tools.
f) Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting edges
are less likely to bind and are easier to control.
g) Use the power tool, accessories and tool bits
etc. in accordance with these instructions, tak-
ing into account the working conditions and
the work to be performed. Use of the power
tool for operations other than those intended
could result in a hazardous situation.

5. Service

a) Have your power tool serviced by a qualified
repair person using only original replacement
parts. This will ensure that the safety of the
power tool is maintained.
b) If the power cord is damaged, it must be replaced
with a special cable available from the manu-
facturer or its customer service.
Additional safety instructions for
grinders and polishers
■ TOXIC DUSTS! Working with the tool can pro-
duce harmful/toxic dusts which represent a
health hazard for the person operating the
appliance and for anyone else in the vicinity.
■ Avoid sanding lead paint or other harmful
materials.
■ Materials containing asbestos may NOT be
processed. Asbestos is a known carcinogen.
Wear safety goggles and a protective
dust mask!
Additional safety instructions for
routers
■ Always hold the appliance using insulated
handle surfaces since the milling cutter can
damage its own power cord. Contact with a
live cable may also cause metal parts of the
appliance to become live and may result in an
electric shock.
PSFS 250 A1