Motor Unit With Multifunction Tool Pkga4 - Parkside PKGA 20-Li A1 Originalbetriebsanleitung

An overview of appropriate blades
can be found in "Spare Parts/Ac-
cessories".
Installing the blade:
1. Push the lever (19) for sawblade un-
locking upwards as far as the stop.
Push the sawblade shaft (20/21) into
the sawblade mounting slot.
2. To unlock, release the lever (19), it will
return to the initial position.
3. Check that the sawblade is secure by
pulling on it.
Removing the sawblade:
4. Press the lever (19) for sawblade un-
locking upwards as far as the stop and
then pull the sawblade out of the saw-
blade mounting.
For certain work, the sawblade
can also be inserted after turning
through 180°.
Operating the sabre saw
1. Before switching the appliance on, en-
sure it is not in contact with the work-
piece.
2. Turn the appliance on.
By using the on/off switch (
can progressively control the stroke
rate.
Gentle pressure: low stroke rate.
Greater pressure: higher stroke rate.
The on/off switch cannot be locked.
3. Place the footplate (
workpiece.
4. Cut with a uniform forward motion.
5. After completion of the work, irst re-
move the blade from the saw cut and
then switch the appliance off.
11) you
18) on the
Motor unit with multi-
function tool PKGA4
Changing the tool
Secure the appliance against
switching on (see "Switch-
ing on/off"). If the appliance
is switched on accidentally,
there is a danger of injury.
1. Push the lever (27) for tool unlocking
upwards as far as the stop.
2. Pull the unlocked tool holder (29) off
forwards.
3. Place the required tool (30/32/33) on
the arbor (28). 12 different positions
are possible.
4. Press the tool holder (29) back into the
central mounting.
5. Push the lever (27) for tool unlocking
forwards again. The tool holder is
ixed to the tool.
Attaching/removing sanding
sheet
The delta sanding plate (30) is itted with Vel-
cro for rapid attachment of the sanding sheet.
Attaching sanding sheet
1. Press the sanding sheet (31) evenly
onto the delta sanding plate (30). En-
sure that the holes in the sanding sheet
are placed above the openings in the
sanding plate.
Removing sanding sheet
2. Simply pull the sanding sheet (31) off
the delta sanding plate (30).
GB IE
39