Additional Safety Instructions - Parkside PKGA 20-Li A1 Originalbetriebsanleitung

GB IE
h) Hold the device by the insulated
gripping surfaces when perform-
ing work in which the cutting tool
may come into contact with hid-
den wiring. Contact with a live wire
can also cause a charge in metal parts
of the device and result in an electric
shock.
5) CAREFUL HANDLING AND USE OF
BATTERY DEVICES
a) Charge the batteries only in
chargers that are recommended
by the manufacturer. Risk of ire if a
charger that is suitable for a speciic type
of battery is used with other batteries.
b) In the power tools, use only the
batteries designed for the pur-
pose. The use of other batteries may
result in injuries and risk of ire.
c) Keep the unused battery away
from paper clips, coins, keys,
nails, screws and other small
metal objects, which could cause
bridging of the contacts. A short
circuit between the battery contacts may
cause burns or ire.
d) If used incorrectly, liquid may
leak from the battery. Avoid
contact with this. In the event of
accidental contact, rinse off with
water. If the liquid gets into eyes, seek
medical assistance. Řeaking battery luid
may cause skin irritations or burns.
6) SERVICE
a) Have your power tool serviced
by a qualiied repair person us-
ing only identical replacement
parts. This will ensure that the safety of
the power tool is maintained.
32
7) SPECIAL SAFETY DIRECTIONS FOR
BATTERY-OPERATED TOOLS
a) Ensure that the device is switched
off before inserting the battery.
Inserting a battery into a power tool that
is switched on may result in accidents.
b) Recharge the batteries indoors
only because the battery charger
is designed for indoor use only.
Risk of electric shock.
c) To reduce the electric shock haz-
ard, unplug the battery charger
from the mains before cleaning
the charger.
d) Do not subject the battery to
strong sunlight over long periods
and do not leave it on a heater.
Heat damages the battery and there is a
risk of explosion.
e) Allow a hot battery to cool be-
fore charging.
f) Do not open up the battery and
avoid mechanical damage to the
battery. Risk of short circuit and
fumes may be emitted that ir-
ritate the respiratory tract. Ensure
fresh air and seek medical assistance in
the event of discomfort. After eye/skin
contact, rinse the affected areas with wa-
ter or a neutraliser and consult a doctor.
g) Do not use non-rechargeable
batteries. This could damage the ap-
pliance.

Additional safety instructions

Warning! Sawing or sanding
can result in the formation of
hazardous dusts (e.g. arising
from materials with paints
containing lead, materials
containing asbestos, metals or
some wood types) which can