Herunterladen Inhalt Inhalt Diese Seite drucken

Use As A Floor-Mounted Appliance; Use Of Adapter Nozzles; Restrictor; Surface Nozzle - Parkside PHLG 2000 D3 Originalbetriebsanleitung

Vorschau ausblenden Andere Handbücher für PHLG 2000 D3:
Inhaltsverzeichnis

Werbung

Verfügbare Sprachen

Verfügbare Sprachen

GB
IE
NI
Use as a floor-mounted
appliance
You can use the device as a
B
floor-mounted appliance. For this
purpose, place the device on the
two bases (9).
Ensure stability and safety and a
heat-resistant surface.
The position as a floor-mounted appli-
ance is also ideally suited to allowing
the device to cool down after use.

Use of adapter nozzles

Before exchanging adapter noz-
zles, the adapter nozzle (5/6/7/8)
and blow-off pipe (4) must be suffi-
ciently cooled down to avoid burns.
Various uses are possible. Always
comply with the safety instructions
and always handle the device with
care and caution.

Restrictor

Place the restrictor (5)
on the blow-off pipe (4).
Use the restrictor (5) to obtain selective
heat.
When using the restrictor (5), pay
particular attention to the heat
development at the cutting point. If
in doubt, do not stay in the same
place for too long in order to avoid
overheating the workpiece.
8

Surface nozzle

Place the surface nozzle (6) on the blow-off
pipe (4).
Use the surface nozzle (6) to obtain heat
over a large surface.
When using the surface nozzle (6),
pay particular attention to the heat
development in adjacent locations
of the cutting point. So that in cases
of doubt, no adjacent component is
overheated.

Spatula nozzle

Place the spatula nozzle (7) on the blow-off
pipe (4).
The spatula form of the nozzle serves the
purpose of the targeted hot air supply to
paint and lacquer surfaces. The paints and
lacquers can be removed with a spatula
and scraper. The spatula (7) itself is not
suitable for removing paint.

Grill lighter nozzle

Place the grill lighter nozzle (8) on the
blow-off pipe (4).
Change the device with the step switch (2)
to level "II". Place the grill lighter nozzle
(8) below the charcoal. Make sure that the
openings of the grill lighter nozzle (8) are
not covered by charcoal as this creates
heat accumulation in the unit, which is a
potential fire hazard In just a few minutes
the charcoal is ignited.
Never use other methods for igni-
ting charcoal at the same time whi-
le using the grill lighter nozzle (8).

Werbung

Kapitel

Inhaltsverzeichnis
loading

Inhaltsverzeichnis