Recalling The Sound Modes; Storing Your Own Sound Adjustments - JVC KD-S9R Bedienungsanleitung

• If the "Link" indicator is lit on the display (with
"SCM LINK" set to "LINK ON" — see page 21),
the selected sound mode can be stored in
memory for the current source, and the effect
applies to the current source.
• If the "Link" indicator is NOT lit on the display
(with "SCM LINK" set to "LINK OFF"), the
selected sound mode effect applies to any
source.
Indication For:
BEAT Rock or disco
music
SOFT Quiet
background
music
POP Light music
SCM OFF (Flat sound)

Recalling the sound modes

Select the source while the "Link"
indicator is lit on the display.
FM
AM
The "Link" indicator starts flashing, and the sound
mode stored in memory for the selected source is
recalled.
Equalization pattern of
the selected sound mode
appears.
Notes:
• You can adjust each sound mode to your preference,
and store it in memory.
If you want to adjust and store your original sound
mode, see "Storing your own sound adjustments"
on the right column.
• To adjust the bass and treble reinforcement levels or
to turn on/off the loudness function temporarily, see
page 17. (Your adjustments will be canceled if
another source is selected.)
18
Preset values
BAS TRE LOUD
+02 00 ON
+01 –03 OFF
+04 +01 OFF
00 00 ON
CD
Sound
mode
indicator
LOUD (loudness) indicator
Storing your own sound
adjustments
You can adjust the sound modes (BEAT, SOFT,
POP) to your preference and store your own
adjustments in memory.
• There is a time limit in doing the following
procedure. If the setting is canceled before you
finish, start from step 1 again.
1
Call up the sound mode you want to
adjust.
• See the left column for details.
SCM
2
Select "BAS" (Bass), "TRE" (Treble) or
"LOUD" (Loudness).
3
Adjust the bass or treble level or turn
the loudness function ON/OFF.
• See page 17 for details.
4
Repeat steps 2 and 3 to adjust the
other items.
5
Press and hold SCM until the sound
mode you have selected in step 1
flashes on the display.
Your adjustment made for the selected
sound mode is stored in memory.
SCM
6
Repeat the same procedure to store
other sound modes.
To reset to the factory settings
Repeat the same procedure and reassign the
preset values listed in the table on the left
column.