Adjust The Display Parameters; Operate The Articulating Camera Head; Turn The Camera Head Lighting On/Off; Av Output - Pce Instruments Pce-Ve 650 Bedienungsanleitung

5.5

Adjust the display parameters

Press the key when in preview mode. There are 3 settings that can be adjusted: saturation,
chromo and brightness. Press
between the settings.
5.6

Operate the articulating camera head

To operate the articulating camera head, use the lever on the camera unit (see chapter 3). You can pivot
the camera head in two directions up to an angle of 90°.
5.7

Turn the camera head lighting on/off

Press the light button on the camera unit (see chapter 3) to switch between the 5 different illumination
levels.
5.8

AV output

Connect an AV cable to the AV out connector of the display unit. Connect the other end to an external
TV or monitor. The image will now be displayed on the connected monitor while the display of the
borescope turns black.
5.9

Connect the device to a computer

The display unit comes with a USB interface which can be connected to a computer. To do so, follow
these steps:
1) Connect the small plug of the USB cable to the display unit.
2) Connect the big plug of the USB cable to a computer.
3) Turn on the device. "Computer connecting" will be displayed.
4) Once you finished data transfer, use the "Safely Remove Hardware" function in windows and remove
the USB cable. After that, you can turn off the display unit.
Manual
and to increase and decrease the value. Press
9
to switch