Werbung
EINSTELLUNGEN UND REGULIERUNGEN
Air filter check
Turn rear pin (1) counterclockwise, remove it and release the saddle from
the front fastening screw.
TE-SMR: Turn forward the housing box complete with the battery (it is not
necessary to remove the battery from its housing box). To gain access to the
air filter, lift a little the electronic power unit (2). Remove screw (3) and the
filter (4). Separate filter (5) from frame (6).
AIR FILTER AND CLEANING
Wash filter with a specific detergent (AGIP" Filter clean foam air detergent
fluid" or similar) then dry it fully (wash filter with gasoline only in case of
necessity). Plunge filter in special oil for filters (AGIP "Foam air filter
protection oil" or similar), then wring it to drain superfluous oil.
: Do not use gasoline or a low flash-point solvent to clean the element.
A fire or explosion could result.
: Clean the element in a well ventilated area, and do not allow sparks
or flames anywhere near the working area.
ASSEMBLY
To ensure tight fit, slightly (C) grease filter edge on side facing filter housing.
While re-inserting the filter into its housing, make surs that piece (A) is
turned upwards and edge (B) is on the left lower side of the filter case.
Reassemble the parts previously removed (battery: connect the positive
cable first).
: If the element assembly is not installed correctly, dirt and dust may
enter and the engine resulting in rapid wear of the piston rings and cylinder.
Part. N. 8000 A7735 (07-2006)
REGISTRAZIONI E REGOLAZIONI
SETTINGS AND ADJUSTMENTS
RÉGLAGES ET CALAGES
AJUSTES Y REGULACIONES
D.57
Quicklinks ausblenden:
Werbung
Kapitel
Fehlerbehebung
