Conrad GX107 Bedienungsanleitung Seite 83

Time = 0 - 250 minutes (0 = GPS is not switched off)

The active time for the rechargeable battery when the GPS receiver is
connected is directly related to this setting. If, e.g. the GPS receiver deactivation
is switched off ("GPSSAVE = 0"), the active time of the rechargeable battery will
be reduced to a few hours (depending on charging state and ambience
temperature).
Reset to Default Settings
Send the following command to reset the default settings (60 min):
RESET GPSSAVE #1513
Test Settings
To test the settings, use the command:
TEST GPSSAVE #1513
Programming Zones
For programming zones, use the command:
SET GPSZONE <Latitude1> <Longitude1> <Latitude2>
<Longitude2> #1513
Latitude1 = upper threshold (North direction)
Latitude2 = lower threshold (South direction)
Longitude1 = right threshold (West direction)
Longitude2 = left threshold (East direction)
Data Input Format:
Latitude – ddmm.mmmmN dd – degrees, mm.mmmm - minutes
e.g. 49° 32.5058" N = 4932.5058N
Longitude – ddmm.mmmmN dd – degrees, mm.mmmm - minutes
e.g. 11° 57.0399E = 01157.0399E

Make sure to fill in missing numbers with "0".
Example: e.g. 3° 3.23"E = 003.032300E
83