Inputs And Outputs; Switching Outputs On/Off (Out1, Out2) - Conrad GX107 Bedienungsanleitung

Inputs and Outputs

This is an autonomously working alarm notification device.
Wrong settings or connections can cause undesired SMS to be sent! Never
enter the phone number that belongs to the SIM card that is inserted in the
module!
Also do not enter the phone number of any other "GX107" or messaging
devices.

Switching Outputs On/Off (OUT1, OUT2)

These are two outputs OUT1 and OUT 2 that can be activated/deactivated by sending an SMS
to the module. A relay is already connected to the output OUT1.
Output OUT2 is a sound transistor that is built as an "open collector". A relay can be directly
connected (e.g. CONRAD order no. 502892).
For switching on output 1 OUT1, use the command:
SET OUT1 #1513
For switching off output 1 OUT1, use the command:
RESET OUT1 #1513
For switching on output 2 OUT2, use the command:
SET OUT2 #1513
For switching off output 2 OUT2, use the command:
RESET OUT2 #1513
When using a voltage above 25 V/AC or 60 V/DC, the installation must only be
performed by a respective specialist.
The device must be powered down before opening its led!
70