Scope Of Delivery; Intended Use - Conrad GX107 Bedienungsanleitung

2. Scope of Delivery

• GSM Remote Control / Alarm Module for "GX107"
• Cable ducts and closing plug
• Operating instructions

3. Intended Use

The GSM remote control / alarm module has 2 switching outputs, which can be switched either
via text message or call (INCALL).
One analogue input (ADC) is able to measure external voltages and can also be reconfigured
for using an optional temperature sensor. The opto coupler input (IN1) serves for switching
signal monitoring.
A GPS receiver can be bought as an accessory (Conrad Order No. 199310). It can be used
to determine the current GPS position and to alert in case a certain area is left. The "GX107"
uses text messages for configuration, communication and alarm. Alarms can be sent to an
email address if the GSM provider used supports this function.
Typical applications are switching door openers, garage door openers, illumination and alarm
systems, controlling door sensors, motion detectors, fire detectors or fill level indicators, as
well as the generation of alarm messages.
The optional GPS receiver can also be used to monitor moving objects.
Any use other than that described above is not permitted. Misuse may not only damage the
device, but also leads to risks such as short circuiting, fire, electric shocks. The product may
not be altered or converted. The safety notes and the maximum permissible operational and
ambient conditions stated in the chapter "Technical Information" must be observed at all times.
Read these operating instructions thoroughly and carefully; they contain a lot of important
information for assembly, commissioning and operation.
49