Requesting Repairs From The Control Panel - Canon ImageRUNNER 2545i Anwenderhandbuch

Requesting Repairs from the Control Panel

If you notice an abnormality with the machine, you can send a repair request from
the touch panel display.
WARNING
Do not connect or disconnect the power cord with wet hands, as this may result
in electrical shock.
CAUTION
Always grasp the power plug portion when disconnecting the power cord.
Pulling on the cord may expose or snap the core wire or otherwise damage the
power cord. If the power cord is damaged, this could cause current to leak,
resulting in a fire or electrical shock.
IMPORTANT
To make repair requests from the touch panel display, the machine must be configured
beforehand. For more information, contact your local authorized Canon dealer.
1
The machine starts up in the Limited
Functions Mode.
NOTE
After the problem with the finisher is
solved, disable the Limited Functions
Mode from the Additional Functions
menu. (See Chapter 3, "Configuring
the Machine's Basic Settings," in the
Reference Guide.)
Press (Counter Check) on the
control panel.
Service Call Message
6
6-13