Cleaning And Maintenance - Parkside PLS 48 D2 Gebrauchanleitung

soldering work .
Clean the soldering tip
„
After cleaning, the soldering tip must be tinned . Tin the hot soldering tip
„
by melting the solder
Bring the soldering tip to the soldering point and heat it .
„
Bring the solder (with flux) between the soldering point and the soldering
„
tip .
Apply additional solder until the entire solder joint is covered .
„
Immediately remove the soldering tip to avoid overheating the molten
„
solder .
Let the solder solidify and avoid vibrations .
„
NOTE
The flux is either contained in the solder or it is applied separately .
f
When purchasing, please find out about the type of application
and the appropriate solder

Cleaning and maintenance

Clean the device after completing the work .
„
Use a cloth and a mild detergent if required to clean the housing .
„
Never use sharp objects, petrol, solvents or cleaners that can damage
„
plastic .
PLS 48 D2
t
on a moist solder sponge
o
.
WARNING! RISK OF INJURY! Always
unplug the
socket and allow it to cool down before
performing any work on the device .
device from
.
s
the mains
27
GB |