Maintenance And Cleaning - Parkside PDRS 27 A1 Originalbetriebsanleitung

Maintenance and cleaning

WARNING! RISK OF INJURY! Disconnect the tool
from the compressed air supply.
CAUTION!
► Before maintenance, clean off any hazardous substances that
may have accumulated on the tool (due to working processes).
Avoid all skin contact with these substances. If the skin comes
into contact with hazardous dusts, this can lead to severe der-
matitis. If dust is produced or swirled up during maintenance, it
can be inhaled.
NOTE
To ensure correct functioning and a long service life for the tool,
pay attention to the following points:
■ Sufficient and continuous oil lubrication is highly important for
optimum functioning.
■ Check the speed and vibration levels after each use.
■ Check the idle speed regularly and after any maintenance is
performed:
use a rev counter and perform the measurement without any
clamped tools. At a residual pressure of 6.3 bar, the idle speed
may not be exceeded under any circumstances.
■ If the tool is exhibiting excessive vibration levels, the cause of the
vibrations must be identified and repaired.
■ Use only the genuine replacement parts recommended by the
manufacturer, otherwise you could put users at risk. In doubt,
contact the Service Centre.
■ Clean the tool with a soft, dry cloth only.
■ Never use sharp or abrasive cleaning agents under any circum-
stances.
PDRS 27 A1
GB │ IE │
59 ■