Hazards Caused By Flying Parts - Parkside PDRS 27 A1 Originalbetriebsanleitung

■ The machines must be serviced regularly to check whether the
rated values and markings required in the present part of ISO
11148 are appended legibly on the machine. The employee/
operator must contact the manufacturer to obtain replacement
stickers for labelling if this is necessary.
Hazards caused by flying parts
■ If a workpiece or one of the accessory parts or even the machine
tool itself breaks, parts can be thrown off at high speeds.
■ Always wear impact-resistant safety goggles during operation,
when replacing accessory parts or during repair or maintenance
work.
The level of the required protection must be evaluated separately
for each individual task.
■ You must ensure that the workpiece has been securely fixed in
place.
■ Check regularly that the rotation speed of the compressed air tool
is not higher than the specified rotation speed appended on the
compressed air tool. These rotation speed tests must be conduct-
ed without any accessory tools attached.
■ Ensure that sparks and fragments created during work do not
present any hazards.
■ Separate the compressed air tool from the compressed air supply
before replacing the attachment or accessories or before you
adjust the settings, service or clean the tool.
■ Ensure that no dangers are created for other persons either.
PDRS 27 A1
GB │ IE │
47 ■