HANSGROHE AXOR Massaud Gebrauchsanleitung, Montageanleitung Seite 2

Safety Notes
Gloves should be worn during installation to prevent
crushing and cutting injuries.
The shower system may only be used for bathing,
hygienic and body cleansing purposes.
The hot and cold supplies must be of equal pres-
sures.
Installation Instructions
• Prior to installation, inspect the product for transport
damages. After it has been installed, no transport or
surface damage will be honoured.
• The pipes and the fixture must be installed, flushed
and tested as per the applicable standards.
• The plumbing codes applicable in the respective
countries must be observed.
• If the instantaneous water heater causes problems or
if you wish to increase the water flow, the EcoSmart
(flow limiter #98465000) located behind the aerator
can be removed.
• This mixer is equipped with a flush stream, which
enhances the natural side of the life element water. As
this flush stream does not contain any air, we recom-
mend the use of Axor Massaud basins or of other very
deep basins to keep water spray to a minimum.
Technical Data
This mixer series-produced with EcoSmart
limiter)
Operating pressure:
Recommended operating pressure:
Test pressure:
(1 MPa = 10 bar = 147 PSI)
Hot water temperature:
Recommended hot water temp.:
Thermal disinfection:
• The product is exclusively designed for drinking water!
2
English
®
(flow
®
max. 1 MPa
0,1 – 0,5 MPa
1,6 MPa
max. 80°C
65°C
max. 70°C / 4 min
Assembly see page 4
Symbol description
Do not use silicone containing acetic acid!
Dimensions (see page 5)
Flow diagram
(see page 5)

with EcoSmart

without EcoSmart
Operation (see page 6)
Hansgrohe recommends not to use as drink-
ing water the first half liter of water drawn
in the morning or after a prolonged period
of non-use.
Cleaning (see page 7)
and enclosed brochure.
Spare parts (see page 8)
Special accessories
(order as an extra)
Installation putty (see page 4)
®
®