Before Use; Grounding Instructions - Husqvarna T 4000 Bedienungsanweisung

• Do not make a hole in the Hepa filter. A broken Hepa
filter can disperse dust.
Introduction
CAUTION: Only use extension cable with
correct rated value for this product. Only
connect to an outlet that is correct grounded.

Before use

WARNING: Before using the dust extractor
make sure that the power and voltage
corresponds with the voltage shown on the
machines rating plate, including extension
cords.
WARNING: Connect to a properly grounded
outlet only. Refer to
on page 8

Grounding instructions

WARNING: The dust extractor must be
grounded. If it should malfunction or
breakdown, grounding provides a path of
least resistance for electric current to reduce
the risk of electric shock. The dust extractor
is equipped with a cord having an
equipment-grounding conductor and
grounding plug. The plug must be inserted
into an appropriate outlet that is properly
installed and grounded in accordance with
all local codes and ordinances.
To start and stop
Push the green button (A) to start the dust extractor.
Push the red button (B) to stop the dust extractor.
A
8
Assembly
Operation
Grounding instructions
B
CAUTION: Always clean the prefilter before
change of bag collection system.
Phase converter
Note: Not applicable to variants sold in Australia or New
Zealand.
WARNING: Electrical work must be done by
an approved electrician.
If the red lamp (A) between the red and the green button
lights up, there is a phase error. Switch 2 of the phases
to reset (B). This is a safety measure to make sure that
the pump does not start to blow.
A
B
180°
877 - 003 -