Disposal; Troubleshooting - Parkside PKS 1500 A2 Bedienungs- Und Sicherheitshinweise

14. Disposal

The equipment is supplied in packaging to prevent it from being damaged in transit. The raw materials in this packaging can be reused or
recycled. The equipment and its accessories are made of various types of material, such as metal and plastic. Defective components must be
disposed of as special waste. Ask your dealer or your local council.
The packaging is wholly composed of environment ally-friendly materials that can be disposed of at a local
recycling centre.
Contact your local refuse disposal authority for more details of how to dispose of your worn out electrical devices.
Old devices must not be disposed of with household waste!
This symbol indicates that this product must not be disposed of together with domestic waste in compliance with the Directive
(2012/19/EU) pertaining to waste electrical and electronic equipment (WEEE). This product must be disposed of at a designated
collection point. This can occur, for example, by handing it in at an authorised collecting point for the recycling of waste electrical
and electronic equipment. Improper handling of waste equipment may have negative consequences for the environment and human health
due to potentially hazardous substances that are often contained in electrical and electronic equipment. By properly disposing of this product,
you are also contributing to the effective use of natural resources. You can obtain information on collection points for waste equipment from
your municipal administration, public waste disposal authority, an authorised body for the disposal of waste electrical and electronic
equipment or your waste disposal company.
Batteries and rechargeable batteries do not belong in the household waste!
As the consumer you are required by law to bring all batteries and rechargeable batteries, regardless whether they contain harm-
ful substances* or not, to a collection point run by the local authority or to a retailer, so that they can be disposed of in an envi-
ronmentally friendly manner.
*labelled with: Cd = cadmium, Hg = mercury, Pb = lead
Remove the batteries from the laser before disposing of the machine and the batteries.

15. Troubleshooting

Fault
Motor does not work.
The motor starts up slowly
and does not reach operating
speed.
Motor makes excessive noise. Coils damaged, motor defective.
The motor does not reach its
full power.
Motor overheats easily.
Saw cut is rough or wavy.
Workpiece pulls away and/
or splinters.
Service information
Please note that the following parts of this product are subject to normal or natural wear and that the following parts are therefore also
required for use as consumables.
Wear parts*: carbon brushes, saw blade, table inserts, dust collecting bags
* Not necessarily included in the scope of delivery!
10 GB
Possible cause
Motor, cable or plug defective, fuses burnt.
Voltage too low, coils damaged, capacitor
burnt.
Circuits in the network are overloaded (lamps,
other motors, etc.).
Overloading of the motor, insufficient cooling
of the motor.
Saw blade dull, tooth shape not appropriate
for the material thickness.
Excessive cutting pressure and/or saw blade
not suitable for use.
Remedy
Arrange for inspection of the machine by a specialist.
Never repair the motor yourself. Danger! Check fuses
and replace as necessary.
Contact the utility provider to check the voltage. Arrange
for inspection of the motor by a specialist. Arrange for
replacement of the capacitor by a specialist.
Arrange for inspection of the motor by a specialist.
Do not use any other equipment or motors on the same
circuit.
Avoid overloading the motor while cutting, remove dust
from the motor in order to ensure optimal cooling of the
motor.
Resharpen saw blade and/or use suitable saw blade.
Insert suitable saw blade.