Operation; Brewing Coffee - Beko CFM4350B Bedienungsanleitung

3

Operation

3.1 Preparation
A
WARNING: First time use: Run the
appliance at least 4 times without
adding coffee.
A
WARNING: Please follow the steps
1 - 2 and 7 - 12 in the "Brewing
Coffee" section.
1. Remove all packaging and stickers and
dispose of them according to applicable legal
regulations.
2. Before using the appliance for the first time,
clean all parts which come into contact with
water carefully. Please see full details in the
"Cleaning and Care" section.
3. Make sure that the appliance is placed in an
upright position and on a stable, flat, clean, dry,
and non-slip surface.

3.2 Brewing Coffee

1. Pull off and fill the glass jug (6) with the required
amount of water, but do not fill past the "10"
mark. The brewed amount of coffee will be 10%
less than the filled water, because it is absorbed
by the coffee grounds and the filter.
C
For the good coffee taste it is
suggested to operate the appliance
with at least 4 cups coffee serving.
For improved heat retention we
C
recommend that you rinse the pot
with hot water before starting the
brewing process.
C
Use only clean, cold, and fresh
drinking water.
Coffee Maker / User Manual
There is a drip hole on the back
of the water reservoir to prevent
C
exceeding the capacity of the coffee
maker. If you add too much water,
it will drip out from the back of the
appliance.
2. Open the filter basket cover (1).
3. Pull out the filter basket (2).
4. Pour the water in the glass jug into the water
reservoir.
5. Fill the filter basket (2) with the desired amount
of ground coffee. To do this, you may use the
supplied measuring spoon.
6. Insert the filter basket (2) back into the housing
and close the filter basket cover (1).
7. Place the glass jug (6) on the warming plate (8).
WARNING: If the glass jug (6) is not
A
placed accurately, the drip-stop (5)
function will not function properly. It
could cause hot water or hot coffee
to overflow.
8. Connect the plug to the wall socket.
9. Turn the appliance on by pushing the On/Off
button (7).
– The On/Off button (7) illuminates and the
brewing process begins.
C
The brewing process can be stopped
at any time by pushing the On/Off
button (7) again.
The appliance is equipped with a
drip-stop (5) located underneath
C
the filter basket (2) and enables
you to briefly remove the glass jug
(6) to pour coffee before the water
has fi-nished running through the
machine.
9 / EN