Connecting Wires To Terminals - Kenwood DNX Serie Installations-Handbuch

Connecting Wires to Terminals

Connector Function Guide
Pin Numbers for Cable Colour Functions
ISO Connectors
External Power
Connector
A-4 Yellow
A-5 Blue/White
A-6 Orange/White Dimmer
A-7 Red
A-8 Black
Speaker
Connector
B-1 Purple
B-2 Purple/Black
B-3 Gray
B-4 Gray/Black
B-5 White
B-6 White/Black
B-7 Green
B-8 Green/Black
6
DNX SERIES
2WARNING
Connecting the ISO Connector
The pin arrangement for the ISO connectors
depends on the type of vehicle you drive. Make sure
to make the proper connections to prevent damage
Battery
to the unit.
Power Control
The default connection for the wiring harness is
described in 1 below. If the ISO connector pins
Ignition (ACC)
are set as described in 2, make the connection as
Earth (Ground)
illustrated.
Connection
Please be sure to reconnect the cable as shown
2 below to install this unit to the Volkswagen
vehicles etc.
Rear Right (+)
Rear Right (–)
1 (Default setting) The A-7 pin (red) of the
Front Right (+)
Front Right (–)
Front Left (+)
Front Left (–)
Rear Left (+)
Rear Left (–)
2 The A-7 pin (red) of the vehicle's ISO
vehicle's ISO connector is linked with
the ignition, and the A-4 pin (yellow) is
connected to the constant power supply.
Ignition cable (Red)
Unit
Battery cable (Yellow)
connector is connected to the constant
power supply, and the A-4 pin (yellow) is
linked to the ignition.
Ignition cable (Red)
Unit
Battery cable (Yellow)
A-7 Pin (Red)
Vehicle
A-4 Pin (Yellow)
A-7 Pin (Red)
Vehicle
A-4 Pin (Yellow)