Applications And Accessories; Wireless Microphones And Transmitters; Conformity And Approval; Before Operation - Monacor TXA-624CD/SW Bedienungsanleitung

•
No guarantee claims for the unit and no liability
for any resulting personal damage or material
damage will be accepted if the unit is used for
other purposes than originally intended, if it is
not correctly connected or operated, or if it is
not repaired in an expert way .
If the unit is to be put out of operation
definitively, take it to a local recycling
plant for a disposal which is not harmful
to the environment .

3 Applications and Accessories

The 2-way bass-reflex speaker system TXA-
624CD / SW with integrated 50 W amplifier and
MP3 / CD player is used for monophonic sound
applications at lectures and other events . The
amplifier is equipped with a receiver module for
two wireless microphones and two inputs for
audio units and a microphone .
For mains-independent operation, an inte-
grated rechargeable battery is provided . This bat-
tery will be charged as soon as the active speaker
system is connected to the mains . Thus, the unit
is ideally suited for mobile applications .
The jacks LINK LINE (25) can be used to inter-
connect multiple active speaker systems for sound
applications in large zones . A passive 4 Ω speaker
system can also be operated in parallel (e . g . the
model TXB-602 / SW with a matching design) .
3.1 Wireless microphones and
transmitters
The following units are available from MONACOR:
Type
Hand-held wireless microphone
Pocket transmitter with
tie clip microphone and head-
band microphone
Transmitter with line level input
for audio signals

3.2 Conformity and approval

Herewith, MONACOR INTERNATIONAL declare
that the active speaker system TXA-624CD / SW
complies with the directive 2014 / 53 / EU . The
EU declaration of conformity is available on the
Internet:
www .monacor .com
14
Model
TXA-800HT
TXA-800HSE
TXA-800ST
The active speaker system is generally approved
for operation in EU and EFTA countries; it is
licence-free and requires no registration.

4 Before Operation

4.1 Setting up the active speaker system

Place the active speaker system as desired or
mount it onto a PA speaker stand (e . g . PAST se-
ries from MONACOR) via the stand sleeve on its
lower side .
The unit can be operated inside its transport
bag: Unzip the zip fasteners of the flaps covering
the speakers, the connections and the operating
elements . Fold up the flaps and secure them with
hook-and-loop fasteners .

4.2 Power supply

The speaker system is supplied with power via
the integrated battery which is charged via the
internal charger .
1) For charging the battery, connect the mains
cable provided to the mains jack (35) and con-
nect the mains plug to a socket (230 V/ 50 Hz) .
2) The LED CHARGE (23) lights up:
red = the battery is being charged
green = the charging process has been com-
pleted
The unit may be operated while its battery is
charged; however, as long as the red LED LOW
lights up, the full power is not available . To
reduce the charging time, switch off the unit
with the POWER switch (31) .
3) When the battery has been fully charged, the
LED CHARGE lights up in green . At maximum
volume, a mains-independent operating time
of up to 10 hours will be possible . A lower
volume will extend the operating time .
4) Recharge the battery when the red LED LOW
lights up .
Important!
Always disconnect the mains plug from the
socket when the battery has been fully charged
(LED CHARGE lights up in green) and the unit
is not operated; otherwise, the battery may
be damaged .