Sawing (With Guide Rail); Plunge Cutting With Guide Rail - Parkside PTSS 1200 B1 Originalbetriebsanleitung

♦ Swivel the motor down and saw forwards with
moderate pressure – never backwards.
Plunge cuts
♦ When making a "plunge cut" which is not at
right angles, secure the base plate of the saw to
prevent any lateral movement. Lateral movement
can cause the saw blade to jam, thus causing
a kickback.
♦ Adjust the desired cutting depth as described
above.
♦ Place the appliance on the workpiece.
♦ Avoid kickback and place the rear edge
against a stop (as referenced in the section

"Plunge cutting with guide rail").

♦ Switch on the appliance as described in
"Switching on and off".
♦ Hold the machine with both hands firmly on the
handles and
NOTE
► The cut width marking
blade guard shows the front and rear cutting
point of a 165 mm at maximum cutting
depth. This applies both to plunge cuts with
guide rail and plunge cuts without guide
rail .

Sawing (with guide rail)

Right-angled sawing with guide rail
♦ Place the guide rail
element on the workpiece.
♦ Place the appliance with the groove
guide rail .
♦ Switch on the appliance as described in
"Switching on and off".
♦ Hold the machine with both hands firmly on the
handles and
Mitre angles up to 45°
♦ Apply the guide rail
element onto the workpiece.
♦ Place the appliance with the groove
guide rail .
PTSS 1200 B1
and pivot it.
on the side of the
with the foam rubber
onto the
and pivot it.
with the foam rubber
onto the
♦ Adjust the cutting angle as described.
♦ Hold the machine with both hands firmly on the
handles and .
♦ Switch on the appliance as described in
"Switching on and off". Place the appliance
with the front part of the base plate
workpiece.
♦ Swivel the motor down and saw forwards with
moderate pressure – never backwards.
Plunge cutting with guide rail
♦ Place the guide rail
element on the workpiece.
♦ Place the appliance with the groove
guide rail .
♦ Adjust the desired cutting depth as described
above.
♦ Place the rear edge (as much as possible)
against a stop.
♦ Switch on the appliance as described in
"Switching on and off".
♦ Hold the machine with both hands firmly on the
handles and
NOTE
► The cut width marking
blade guard shows the front and rear cutting
point of a 165 mm cutting blade at maximum
cutting depth. This applies both for plunge
cuts with guide rail
without guide rail
Further applications are not permitted.
on the
with the foam rubber
onto the
and pivot it.
on the side of the
and plunge cuts
.
GB │ IE │
21 ■