Introduction; Intended Use; Features; Package Contents - Parkside PTSS 1200 B1 Originalbetriebsanleitung

PLUNGE SAW PTSS 1200 B1

Introduction

Congratulations on the purchase of your new appli-
ance. You have selected a highquality product. The
operating instructions are part of this product. They
contain important information on safety, usage and
disposal. Before using the product, familiarise your-
self with all operating and safety instructions. Use
the product only as described and for the specified
areas of application. Please also pass on these
operating instructions to any future owner.

Intended use

This circular saw (hereinafter "appliance" or "ma-
chine") is designed for longitudinal, cross and
plunge cuts in firmly supported solid wood, chip
board, plastics and lightweight construction mate-
rials. Working with metals is not permitted. This ap-
pliance can be used with the provided guide rails
– exclusively for the cutting techniques described.
Any other uses of or modification to the appliance
is deemed to be improper and carries the risk of
serious personal injury. Not for commercial use.

Features

Safety lock-out
ON/OFF switch
Handle
Hex key (small)
Hex key (large)
Motor unit
Chip ejector adapter
Fine adjustment screws for 0° cutting angle
Fine adjustment screw for 45° cutting angle
8a
Baseplate
Markings for cutting line
9a
Eccentric screw (2 x)
Adjustment wheel for cutting
angle adjustment (2 x)
Cutting depth adjustment
Cutting depth scale
Saw blade
Clamping screw/plain washer
14a
│ GB │ IE
■ 14
Panel cut out
14
b
Additional handle
Cutting width marking
Chip ejector (rotatable)
Clamping lever for changing saw blades
Spindle lock
Groove for guide rails
Guide rail
Grub screws
Connector
X flange (factory-fitted)

Package contents

1 circular saw
1 saw blade 165 mm / 24 teeth (pre-fitted)
2 guide rails
1 connector
1 chip ejector adapter
2 Hex keys
1 set of operating instructions

Technical data

Rated voltage:
Nominal power input: 1200 W
Idle speed:
Sawblade mount:
Saw blade:
165mm
Main blade width:
Tooth thickness:
Max. cutting depth:
max. 6 5 mm
Protection class:
Accessories:
230 V ~ 50 Hz
(Alternating current)
n = 5200 rpm
0
ø 20 mm
165 mm
1.5 mm
2.6 mm
56 mm at a 90°
mitre angle
42 mm at a 45°
mitre angle
5 mm less with guide rails
II /
Guide rails 2 x
700 mm x 180 mm
PTSS 1200 B1