REX RFC2810V Benutzerinformation Seite 12

12
Problem
There is too much frost and
ice.
The compressor does not
start immediately after
pressing the "FastFreeze, or
after changing the tempera‐
ture.
Water flows on the rear
plate of the refrigerator.
Water flows inside the refrig‐
erator.
Water flows on the floor.
Temperature cannot be set.
The temperature in the ap‐
pliance is too low/too high.
Possible cause
The door is not closed cor‐
rectly.
The "FastFreeze is switch‐
ed on.
The door is not closed cor‐
rectly or the gasket is de‐
formed/dirty.
The water drainage plug is
not correctly positioned.
Food products are not
wrapped properly.
Temperature is set incor‐
rectly.
This is normal, no error
has occurred.
During the automatic de‐
frosting process, frost
melts on the rear plate.
Food products prevent the
water to flow into the wa‐
ter collector.
The water outlet is clog‐
ged.
The melting water outlet is
not connected to the evap‐
orative tray above the
compressor.
The "FastFreeze function"
is switched on.
The temperature regulator
is not set correctly.
The door is not closed cor‐
rectly.
Solution
Refer to "Closing the door".
Refer to "FastFreeze function".
Refer to "Closing the door".
Position the water drainage
plug in the correct way.
Wrap the food products better.
Refer to "Operation" .
The compressor starts after a
period of time.
This is correct.
Make sure that food products
do not touch the rear plate.
Clean the water outlet.
Attach the melting water outlet
to the evaporative tray.
Switch off "FastFreeze func‐
tion" manually, or wait until the
function resets automatically
to set the temperature. Refer
to "FastFreeze function".
Set a higher/lower tempera‐
ture.
Refer to "Closing the door".