Midland Alan 52 DS Handbuch Seite 4

e. AM/FM: it shows the emission mode and the Noise Blanker activation (in this
case, the indication will blink)
f. SC: SCAN function activated
g. DW: DUAL WATCH function
h. LOW function activated
i. The received signal strength and the power of the transmitting signal
j. RX/TX: TX=transmit mode; RX=receive mode
k. Frequency band selected
7. EMG button: emergency channel. By pressing this button, the unit automatically skips
to Channel 9 (emergency channel). The display will show EMG. It will not be possibile
to change accidentally the channel. To cancel this function, press the button again.
8. A/F–LCR button: to select AM mode or FM mode; the modulation you choose will
appear on the display. If you select a frequency band operating in FM mode only, the
A/F–LCR button will activate the LCR function (Last Channel Recall).
9. Microphone: during transmission, keep your mouth 4 cm far from the unit, and speak
with a normal tone of voice to the microphone.
10. H/L button: it selects the output power level during trasmission.When the unit is tur-
ned on, it always transmits with high power (4W). By pressing this button, the unit will
transmit with low power (1W). The display will show LOW. Press again the H/L button
to return to HIGH power level.
11. LOCK button: it allows you to lock the keyboard, thus avoiding accidental use of the
keys.
12. Q.UP - Q.DOWN buttons: to skip 10 channels up (Q.UP) or 10 channels down
(Q.DOWN).
13. Loudspeaker
14. Dual Watch: this function allows the synthonization on two different channels at the
same time. Thanks to this function, you can monitor a second channel. When a signal
on the second channel is received, the conversation on the first channel is automatical-
ly interrupted and the receiver switches on the second channel. The monitoring starts
again 4 seconds after the signal end.
Alan52 DS user manual | 3