Maintenance And Cleaning - Parkside PGG 15 D3 Originalbetriebsanleitung

plastic, ceramic and leather. Use the templates
scope of delivery to do so.
Hold the product at an angle like you would a pen. Your arm
should be placed on a table while doing so.
Lead the engraving point
ing a little surface pressure. Practice the feed rate on scrap
material for the best results.
Note: The engraving point
ery is made from tungsten steel. It is therefore not suitable for
engraving electronic media such as CDs, DVDs, etc. These
materials and their readability could be damaged.

Maintenance and cleaning

Unplug the mains plug from the socket prior to per-
forming maintenance or repairs.
Clean the product regularly, preferably immediately after
every use.
Use a dry cloth to clean the housing. Never use petrol,
solvents or cleaning agents that attack plastic.
over the work piece while apply-
5
included in the scope of deliv-
5
RISK OF ELECTRIC SHOCK!
included in the
7
GB/IE 37