Step 6:
Assembly of counters, ball in cup, rubber handle and rod cap.
Slide the rubber handle (16) as figure shows with help from a little bit soap
water onto the grip rod and put on each end of grip rod a rod cap (17).
Place the counters (11) in the right position of short side board (3) and fix it
with screws 4x45 mm (32). Turn in the 2-piece ball in cup unit (9) at the hole
at long side board (2) and secure with screw 4 x16 mm (30).
Step 7:
Checks:
Check the correct installation and function of all screwed and plug con-
nections.
Installation is thereby complete.
Note:
Please keep the tool set and the instructions in a safe place as these may
be required for repairs or spare parts orders becoming necessary later. The
Kicker should carry with 2 persons into desired position. Don't pull or push
the kicker on one side!
Rules of the game:
1.
There are two versions of games -either men against men or team
against team (each team with two players). A coin decides which
player starts with the thrown in ball. The winner of the throw coin
then throws the ball into the middle of the playing field.
2.
For passing and shooting goals, you have to pull or push and turn
the grip rods. Turning around the grip rods is not allowed.
3.
If you are playing in teams it is not allowed to change places.
4.
When the ball hits a goal, the team may pick up a point.
5.
WINNER: The winner of the match is who reaches first a certain
number of goals which is layed down before the game starts.
6.
After finishing a game the men or team have to change the sides.
7.
Pushing or pulling the playing ground is not allowed.
8.
Playing the ball with hand is irregular during the game.
9.
„DEATH-BALL": If the ball lays in an area where no one can get it,
you have to take the ball and place it in the nearest corner to go on
with the game.
10. „OUT": If the ball gets out of the playing ground during the game, it
must be started again in the middle point.
11