Maintenance And Cleaning; Disposal - Parkside PHP 500 D2 Originalbetriebsanleitung

Gluing:
♦ Pull the trigger to control the flow of glue in
accordance with your requirements.
♦ Apply the glue in spots. For flexible materials,
such as textiles, apply the glue in zigzag lines.
♦ Press the two workpieces to be bonded together
immediately after applying the glue and hold
for about 30 seconds. The glued bond is ready
after about 5 minutes.
♦ During breaks in work, put the glue gun down
on the plastic stand
charger .
♦ Remove any glue residue after it has cooled
down with a sharp knife. Bonded joints can be
released by heating.
Switching the appliance off:
♦ Unplug the appliance from the mains socket.
Changing the nozzles:
The temperature of the nozzle
temperature of around 200°C.
200
■ Wear protective gloves.
♦ Heat the appliance up for about 5 minutes.
Replace the nozzle
■ Risk of burns! Touch the nozzle
thermal protection
NOTE
Hold the appliance vertically with the nozzle
pointing upwards, otherwise the glue could
drip out.
│ GB │ IE
■ 10
or replace it in the
reach a
when hot.
only by the
. The nozzle tip is hot!

Maintenance and cleaning

WARNING! ALWAYS REMOVE THE
POWER PLUG FROM THE POWER
SOCKET BEFORE CLEANING THE
APPLIANCE.
■ The glue gun is maintenance free.
■ Keep the appliance clean and dry at all times.
■ Never permit liquids to enter inside the
appliance. Use a cloth to clean the housing.
Never use petrol, solvents or cleansers which
can damage plastic.

Disposal

The packaging is made from environmen-
tally friendly material and can be
disposed of at your local recycling plant.
Do not dispose of electrical ap-
pliances with normal domestic waste!
As required by European Guideline 2012/19/EU,
worn-out electrical appliances must be collected
separately and fed into an environmentally compa-
tible recycling process.
Your local community or municipal authorities can
provide information on how to dispose of the worn-
out appliance.
PHP 500 D2