Märklin 60905 Handbuch Seite 6

Setting the Digital Address:
The address for the locomotive decoder is set with
the 8 coding switches => Table 1.
The address set during the conversion is on
page 21.
Setting the maximum Speed:
Turn the pot adjustment to the right = higher top
end speed.
10
Turn the pot adjustment to the left = lower top end
speed.
Setting the Acceleration and Braking Delay:
Turning the pot adjustment to the right: increases
the acceleration and braking delay.
Turning the pot adjustment to the left: decreases
the acceleration and braking delay.
Turning the Function Outputs On/Off
Only the 6021 Control Unit can be used as a digital
central unit. The four coding switches on the back
of the Control Unit for the operating modes must
either be set at UNIVERSAL (switches 1, 3 and 4 at
off, switch 2 at on) or CONTROL UNIT (switches 1,
2 and 3 at on, switch 4 at off).
The electrical users indicated in the technical
information under "function" are turned on with the
"function" button on the 6021 Control Unit and off
with the "off" button.
The electrical users indicated in the technical
information under "f1" ("f2") are turned by pressing
the button "f1" ("f2") on the 6021 Control Unit and off
by pressing the corresponding button a second time.
Turning function "f4" on with the button "f4" on the
Control Unit sets the acceleration and braking delay
to the minimum value.
11